Manually set network settings

If your network doesn’t automatically assign network settings to your computer, you may have to manually enter the settings yourself. This topic assumes that you already know the correct settings to use. If not, you may need to ask your network administrator or look at the settings of your router or network switch.

To manually set your network settings:

  1. Go to the desktop and start typing Settings.

  2. Click on Settings.

  3. If you plug in to the network with a cable, click Network. Otherwise click Wi-Fi.

    Make sure that your wireless card is turned on or a network cable is plugged in.

  4. Click the settings button.

    For a Wi-Fi connection, the settings button will be located next to the active network.

  5. Select the IPv4 or IPv6 tab and change the Method to Manual.

  6. Type in the IP Address and Gateway, as well as the appropriate Netmask.

  7. In the DNS section, switch the Automatic switch to off. Enter the IP address of a DNS server you want to use. Enter additional DNS server addresses using the + button.

  8. In the Routes section, switch the Automatic switch to off. Enter the Address, Netmask, Gateway and Metric for a route you want to use. Enter additional routes using the + button.

  9. Click Apply. If you are not connected to the network, open the system menu from the right side of the top bar and connect. Test the network settings by trying to visit a website or look at shared files on the network, for example.